Polka dot beam spliter / PDBS70-50.8C1.5

The polka dot beamsplitter is a beamsplitter that has aluminum coating of halftone dots (polka dots) on the glass substrate. It has a low dependence on the incident angle and can be used in a wide range of wavelengths from ultraviolet region to the infrared region.

Contact us

Part Number
PDBS70-50.8C1.5
S$590.90
◦Reflectance to transmittance ratio is manufactured by adjusting the area ratio of the points that have been coated.
◦Unlike dielectric beamsplitters, the polka dot beamsplitter reflectance and transmittance ratio does not change as the incident angle changes.
◦There are two sizes available φ25.4mm and φ50.8mm diameter and three types of reflectance to transmittance ratio, 7:3, 5:5 and 3:7.
More Information
Catalog Code W3173
RoHS Yes
CE No
Download Product's Datasheet
Guide ▶We also offer different sizes
Attention ▶When used with a laser beam with high interference, diffraction occurs.
▶When light is incident, scattering light by the halftone dot occurs.
▶By the effect of the refractive index and the thickness of the substrate, the optical path of the transmitted light over the incident light will move by 0.5 extent parallel.
▶When the incident beam diameter is very thin, it is not possible to separate into the split ratio.
▶Do not clean with water or solvents. It may cause surface deterioration.
▶Please use in the environments which are non-condensing and less dust. If the dust or dirt is deposited, please do not blow but blow it off gently with dried air.
Specifications
MaterialSynthetic fused silica
Parallelism<3′
CoatingFront Surface: Al+MgF2
Rear Surface: Uncoated
Recommended angle of incidence0°~45°
Wavelength range250~2200nm
Surface Quality (Scratch-Dig)80−50
Dot pitch0.3mm
Clear apertureCircle except surrounding 1.5mm
Divergence ratio (reflectance 70:30
Diameter φDφ50.8mm
Thickness t1.5mm
Transmmittance30-5+0